BPNPT - 0 27426 33060, SPRAY POLYURETHANE CLEAR SAT
- MSDS: BPNPT
- Manufacturer: MINWAX CO INC
- Product Name: 0 27426 33060, SPRAY POLYURETHANE CLEAR SAT
- National Stock Number: 8010-00N033084
Product Identification
Product ID:0 27426 33060, SPRAY POLYURETHANE CLEAR SAT
MSDS Date:07/30/1986
FSC:8010
NIIN:00N033084
MSDS Number: BPNPT
Responsible Party
MONTVALE, NJ 07645
US
Emergency Phone: 201-391-0253;201-573-5700
Info Phone: 201-391-0253
Cage: HO333
Contractor
Telephone: 800-523-9299/216-566-2917
Cage: 0K1A4
Ingredients
STODDARD SOLVENT; (MINERAL SPIRITS)
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 3.8%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM; 9293
ADDITIVES
Fraction By Weight: 0.3%
TOLUENE
CAS: 108-88-3
RTECS: XS5250000
Fraction By Weight: 9.0%
OSHA PEL 200 PPM/150 STEL
ACGIH TLV: 50 PPM; 9293
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
BUTYL ALCOHOL
CAS: 71-36-3
RTECS: EO1400000
Fraction By Weight: 2.0%
OSHA PEL 100 PPM
ACGIH TLV: S, C 50 PPM; 9293
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
METHANE, DICHLORO-; (METHYLENE CHLORIDE)
CAS: 75-09-2
RTECS: PA8050000
Fraction By Weight: 30%
OSHA PEL 500 PPM; 1000, C
ACGIH TLV: 50 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
PROPELLANTS CONSISTING OF INGREDIENTS 9-10
RTECS: 9999999ZZ
PROPANE
CAS: 74-98-6
RTECS: TX2275000
Fraction By Weight: 13.5%
OSHA PEL 1000 PPM
ACGIH TLV: SIMPLE ASPHYXIANT
PROPANE, 2-METHYL-; (ISOBUTANE)
CAS: 75-28-5
RTECS: TZ4300000
Fraction By Weight: 13.5%
ACUTELY OR CHRONICALLY EXPOSED TO CHLOROCARBONS
RTECS: 9999999ZZ
NAVY LISTING OF OCCUP REPROD HAZ. SEEK CONSULTATION
RTECS: 9999999ZZ
LIST INFORMATION & SAFE HANDLING & EXPOSURE
RTECS: 9999999ZZ
PROD. DO NOT CUT/PUNCT/WELD ON/NEAR CONTR. AVOID
RTECS: 9999999ZZ
WATERING, HDCH/DIZZ, INCR FRESH AIR & LEAVE AREA.
RTECS: 9999999ZZ
PERSONS W/KNOWN RESP/HEART AILMENTS SHOULD EXERCISE
RTECS: 9999999ZZ
CHLORIDE. DO NOT TAKE INTERNALLY. NO SMOKING IN AREA
RTECS: 9999999ZZ
FLAMES/HOT SURF. HEAT &/OR UV RADIA MAY CAUSE FORM
RTECS: 9999999ZZ
FRESH AIR ENTRY DURING APPLICATION AND DRYING.
RTECS: 9999999ZZ
PIGMENTS
Fraction By Weight: 0.8%
VEHICLE (TYPE NOT SPECIFIED)
Fraction By Weight: 27.1%
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHAL:CAN CAUSE NASAL & RESP IRRIT,
DIZZ, WEAK, FATG, NAUS, HDCH, NERV IRRITABILITY, POSS UNCON &
ASPHY. IN CONFINED AREAS, VAPS IN HIGH CONC ARE ANESTH. INGEST: CAN
CAUSE GI IRRIT, NAUS, VOMIT & DIAR R. ASPIR OF LIQ INTO LUNGS CAN
CAUSE CHEM PNEUM WHICH CAN BE FATAL. SKIN:CAN CAUSE DEFAT & DRY OF
SKIN (EFTS OF OVEREXP)
Explanation of Carcinogenicity:METHYLEHE CHLORIDE: GROUP 2B(IARC),
ANTICIPATED TO BE CARCINOGEN (NTP).
Effects of Overexposure:HLTH HAZ: WHICH MAY RSLT IN IRRIT & DERM. EYE:
CAN CAUSE SEV IRRIT, RED, TEAR/BLURRED VISION. CAN LEAD TO CNS
DEPRESS. CHLOROCARBON MATLS HVE PRDCD SENSIT OF MYOCARDIUM TO
EPINEPHRINE IN LAB ANIMALS & COULD HAVE SIMIAR EFT IN HUMANS.
ADRENOMIMETICS (E.G., EPINEPHRINE) MAY BE CONTRAINDICATED EXCEPT
FOR (SUPP DATA)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:INGEST: DO NOT INDUCE VOMIT. CALL PHYS IMMED. KEEP WARM &
QUIET. ASPIR OF MATL INTO LUNGS DUE TO VOMIT CAN CAUSE CHEM PNEUM
WHICH CAN BE FATAL. SKIN: WASH THORO W/PLENTY OF H2O. IF IRRIT
PERSISTS, GET MED ATTN. EYE: REMOVE CONT LENSES, FLUSH W/PLENTY OF
H2O FOR @ LST 15 MIN. CALL PHYS. INHAL: REMOVE TO FRESH AIR.
MAINTAIN RESP AS NECESSARY & CALL PHYSICIAN.
Fire Fighting
Flash Point Method:TOC
Flash Point:<20F,<-7C
Lower Limits:1.0%
Upper Limits:3.1%
Extinguishing Media:CO2, DRY CHEMICAL AND ALCOHOL FOAM.
Fire Fighting Procedures:NIOSH/MSHA APPRVD PRESSURE DEMAND SCBA & FULL
PROT EQUIP. H2O IS INEFTIVE AS EXTING AGENT BUT CAN BE USED TO KEEP
FIRE EXPOSED CONTRS COOL.
Unusual Fire/Explosion Hazard:OVER-HEATED CANS WILL EXPLODE. WHEN BURN,
PROD GIVES OFF TOX BY-PROD (SUCH AS CO), THEREFORE, BRTHG OF FUMES,
SMOKE & GASES GIVEN OFF DURING BURNING (SUPP DATA)
Accidental Release
Spill Release Procedures:PROVIDE ADEQ VENT. REMOVE IGNIT SOURCES FROM
SPILL AREA. UTILIZE SAND, RAGS, PAPER, VERMICULITE, FLOOR
ABSORBENT, OR OTHER ABSORBENT MATERIAL & PLACE IN LEAK-PROOF DRUMS
FOR DISPOSAL. USE PROTECTIVE E QUIPMENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT USE/STORE NEAR HEAT/SPARKS/OPEN
FLAME/OTHER SOURCES OF IGNIT.
Other Precautions:DO NOT STORE ABOVE 120F. EXPOS TO DIRECT
SUNLIGHT/OTHER SOUCES OF HEAT MAY CAUSE BURST. AVOID SPONT COMBUST
OF CONTAMD RAGS & OTHER EASILY IGNITABLE ORG ACCUMULATIONS BY IMMED
IMMERSION IN H2O. EMPTY CONTRS MAY RETAIN RESIDUES OF (ING 14)
Exposure Controls
Respiratory Protection:IF ADEQ VENT CANNOT BE MAINTAINED, USE
NIOSH/MSHA APRROVED RESPIRATORY PROTECTION (TC23/EQUIVALENT) OR
LEAVE AREA. USE NIOSH/ MSHA APPROVED FULL FACE/HALF-MASK AIR
PURIFYING RESPIRATOR W/ORGANIC CARTR IDGE TO PREVENT OVEREXPOSURE.
Ventilation:PROVIDE A CONSTANT FLOW OF FRESH AIR TO MEET TLV
REQUIREMENTS. OPEN WINDOWS & DOORS/USE OTHER MEANS TO PERMIT (ING
19)
Protective Gloves:USE RUBBER, NEOPRENE OR VITRON GLOVES.
Eye Protection:CHEM WORK GOG & FULL LENGTH FSHLD.
Other Protective Equipment:HAVE EYE BATH AND SAFETY SHOWER NEARBY
DURING USE.
Work Hygienic Practices:WAS W/SOAP & PLENTY OF H2O BEFORE EATING,
DRINKING, SMOKING OR USING TOILET FACILITIES.
Supplemental Safety and Health
EXPLO HAZ: SHOULD BE AVOIDED. WHEN METHYLENE CHLORIDE IS EXPOS TO HOT
SURF/OPEN FLAME PHOSGENE CAN BE EVOLVED. THERMAL DECOMP PROD MAY
INCL HCL & PHOSGENE . HAZ DECOMP: CAN CAUSE THERMAL DEGRADA TION
W/EVOLUTION OF HCL & SM AMTS OF PHOSGENE & CHLORINE. EFTS OF
OVEREXP: LIFE-SUSTAINING USES IN HUMANS (ING 11)
Chemical Properties
HCC:V3
Boiling Pt:B.P. Text:0F,-18C
Vapor Pres:340
Vapor Density:2.82
Evaporation Rate & Reference:0.1(BUTYL ACETATE=1)
Solubility in Water:NIL
Appearance and Odor:AROMATIC ODOR, SPRAY MIST: AMBER LIQUID.
Percent Volatiles by Volume:87.1
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT, DIRECT SUNLIGHT OR OTHER SOURCES OF
HEAT.
Hazardous Decomposition Products:METHYLENE CHLORIDE PRDCES PHOSGENE.
INCOMPLETE COMBUST PRDCES CO, CO2 & UNIDENTIFIED ORG CMPDS. OPEN
FLAMES (SUPP DATA)
Disposal
Waste Disposal Methods:IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL
REGULATIONS. BURYING IN AN APPROVED LANDFILL. KEEP OUT OF SURFACE
WATERS AND ANY WATER COURSES OR SEWERS ENTERING OR LEADING TO
SURFACE WATER. DO NOT INCINE RATE AEROSOL CAN.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.